control condition
英 [kənˈtrəʊl kənˈdɪʃn]
美 [kənˈtroʊl kənˈdɪʃn]
网络 控制条件; 控制状态; 控制环境
英英释义
noun
- a standard against which other conditions can be compared in a scientific experiment
- the control condition was inappropriate for the conclusions he wished to draw
双语例句
- The effects of environmental factors on NH/ release in sediment slurries from Chaohu lake were studied under a laboratorial control condition.
在实验室控制条件下,研究各环境因子对巢湖沉积物湿样中NH4~+释放的影响。 - IRCFG is used for describing the paths of messages event in UML sequence diagrams by control condition of messages.
根据UML顺序图中消息控制条件,使用函数间约束的控制流图(IRCFG)描述出UML顺序图中的消息事件序列。 - In design of homogeneous earth dam, sudden drawdown of water level is always a control condition for stability of upstream slope.
在均质土坝设计中,水位骤降通常是上游边坡稳定计算时需控制的工况。 - Results indicated, for the self-reported measures, regulators in the suppression condition reported a lower self-regard and a lower satisfaction with the conversation than both the regulators in the reappraisal and the participants in the control condition.
结果发现在自陈量表上,以抑制方式调节情绪者较之于情绪重评者与控制组参与者表现出较低之自我评价与互动满意度。 - Hand picking, hand selection, ferment under temperature control condition to extract the noble of fruit essence, aging in oak barrel.
人工采摘,人工分选,控温发酵,以完美体现葡萄品种的高贵特性,橡木桶陈酿。 - The model can be supplied boundary and control condition for local model and offered argumentation for port, sea-route and important paddle engineering which lies in main artery and estuary region.
模型可用于珠江河口综合治理规划工程方案和分期实施工程方案的可行性论证;可为研究局部河段整治工程的局部模型提供边界和控制条件; - General Transient Equivalent Circuit and Correction of Field Acceleration Control Condition for Induction Motor
感应电动机的通用等值电路和磁场加速控制条件的修正 - The bar stock room environmental should meet the control condition as specified in AAAAA.
芯片储存室之环境条件必须符合AAAA。 - Factors influencing the particle size of Glauber ′ s salt is analyzed and the optimum process control condition is proposed.
文章分析了在元明粉生产过程中,影响产品粒径大小的因素,提出了最佳的工艺控制条件。 - There are new analytical and calculating methods of the varying pitch screw for rational design as well as control condition of transported containers or workpieces in stable motion.
其中包括:合理设计变螺距螺杆的新的分析计算方法,以及被供送物件或容器实现稳定运动的可控条件。
